https://harrissupplyind.com - To Order Parts Call 608-268-8080
OPERATIONS
980200 05/28/04
3-2
!
CAUTION
CONTROLS
1)
Traction Lever:
by pressing this lever, the
machine will start moving forwards.
2)
Filter Shaker Lever:
This lever operates the
filter shaker to clean the filter.
3)
Flap Raise Lever
4) Front Hopper Unlocking Lever
5)
Side Brush Control
Lever:
switch the lever to ON and the side
brush will move to work position and start
spinning. To stop the brush, switch the lever
to OFF.
6)
Timer:
Displays the total amount of work
hours of the machine.
7)
Charge Indicator Light:
Light indicates the
state of battery during operation.
8)
Air Suction Inlet Knob:
(located under the
cover) this opens or closes the suction valve.
9)
Battery Charge Connector:
Connector
allows the battery to be charged.
10) Suction Switch
11)
Key Switch:
Starts and stops all of machine
functions.
STARTING THE MACHINE
1.
The machine must be used by authorized personnel only.
DO NOT leave the machine UNATTENDED when it is
running. Turn off power and remove the key before leaving
the machine.
2.
3.
To start the machine carry out the following steps:
1. Make sure the side brush is
OFF
.
2. Turn the power switch to the
ON
position. Wait 10
seconds before moving the machine.
4.
3. Check the battery indicator to assess whether the
battery is fully charged or not. If you do not have
enough battery power to operate the machine, turn
power of to machine and proceed to recharging the
battery. (see section on re-charging battery)
4. Pull the traction lever to start cleaning.
NOTE:
if you wish to engage the side brush at this
time, make sure to switch to the ON position for the
side brush.
NOTE
:
This unit has an automatic device built in to prevent
usage of the machine beyond a certain battery charge limit.
The machine will not function until the battery has been fully
charged.
TIPS FOR OPERATION
After you have become acquainted with the start up
procedure, the following are tips to ensure the best results
from your sweeper. These tips will also help reduce damage
to your machine.
7.
6.
8.
5.
•
DO NOT use the machine to clean up wires, ropes
or straps.
•
DO NOT use the machine to soak up or clean up
liquids of any kind.
•
When using the machine on light but bulky material
(sheets of paper, leaves, etc.), raise the front part of
the machine by pressing down the handlebar so that
the machine may tackle the debris easier.
11.
10.
9.
•
Operate the filter shaker at the end or your work
session. (see the panel filter section)
•
Make sure the center brush is correctly adjusted.
(see adjusting the center brush)