13
INTERIOR CUTTING (FIG. 13)
1. Lay out the design on the workpiece (1). Drill a 1/8” (3 mm) hole
(4) through the workpiece.
2. Remove the blade (3) by turning the quick tension release lever
(2) counterclockwise.
Refer to BLADE REMOVAL AND INSTALLATION.
3. Place the workpiece on the work table (5) with the hole (4) over
the access hole in the work table (5).
4. Install the blade (3) through the hole in the workpiece and push
down the quick
tension release lever (2).
5. Follow steps 3-8 under BASIC SCROLL SAW OPERATION.
6 Reinstall the blade in the scroll saw for further normal cutting.
.
SAW TRANSPORTATION (FIG. 13)
Transport the saw by the designated carrying handle (6) located on the upper arm of the body.
