www.raketengines.com
www.raketengines.com
18
Raket 95 Manual - English
Raket 95 Manual - English
19
diameter at the connection for transition to
the cylinder connection should be 20.50
mm.
Parts subject to wear and tear such as
the diaphragm, gaskets and needle valve
must be original.
The throttle shaft should be an original
Tillotson with a lever for connection of the
throttle cable.
7. Carburettor flange
The carburettor flange should always
be assembled and labelled with article
number 35061.
8. Inlet flange
The rubber inlet flange should be labelled
with article number 35065 and may not be
altered in any way. The dividing plate of
treated Bakelite should be assembled.
9. Ignition system
The ignition system should be original
Selettra and no modifications are allowed.
The ignition coil and flywheel should
be labelled with Selettra. The minimum
weight is 390g.
The flywheel wedge should be assembled
and may not be altered.
The picture illustrates the flywheel with
flange hub for manual starting. The hub
should not be removed.
10. Exhaust system
The exhaust system, consisting of cyl-
inder connection and complete silencer,
may not be altered or modified in any
way. The attachment of the silencer onto
the cart is open to choice, but it must be
of such a nature that the original silencer
can be used without any alterations what-
soever.
The exhaust system for Micro has a re-
strictor washer assembled at the cylinder
connection. The restrictor washer has a
diameter of 14 mm.
One can divide the silencer by drilling out
the rivets and replacing them with suitable
screws. When the silencer is divided one
is able to check on the amount of damp-
ing material. This should be done at least
once every season, or when you notice a
change to the sound of the exhaust.
11. Centrifugal clutch
The clutch is an one piece steel clutch
with expandable arms.
The clutch is a security feature and abso-
lutely no alterations or modifications are
allowed. In other words it is not permitted
to change the clutch weights or the clutch
springs in order to alter the number of rpm
at which the slip clutch engages.
The clutch should be fully engaged at
max 5,000 rpm.
The clutch drum has a sprocket with 11
teeth.
12. Covers
The covers are safety features designed
to avoid contact with the rotating and
warm parts of the engine, and absolutely
no alterations or modifications are permit
-
ted. The kart may not be driven without
the covers.
13. Starter system
The engine is equipped with an electric
starter system as standard. The starter
motor should be an original Raket 95.
The engine may even be equipped with
a manual starter system also known as a
Magnapull starter.
This means that a flange hub may be as
-
sembled onto the flywheel.
Summary of Contents for Raket 95
Page 1: ...Owners Manual ENGLISH ...
