Page 2 of 8
IN006 Rev G
RadonAway Ward Hill, MA.
GP500 Fan Installation Instructions
Please Read and Save These Instructions.
DO NOT CONNECT POWER SUPPLY UNTIL FAN IS COMPLETELY
INSTALLED. MAKE SURE ELECTRICAL SERVICE TO FAN IS LOCKED
IN "OFF" POSITION. DISCONNECT POWER BEFORE SERVICING FAN.
1.
WARNING!
Do not use fan in hazardous environments where fan electrical system
could provide ignition to combustible or flammable materials.
2. WARNING!
Do not use fan to pump explosive or corrosive gases.
3.
WARNING!
Check voltage at the fan to insure it corresponds with nameplate.
4. WARNING!
Normal operation of this device may affect the combustion airflow
needed for safe operation of fuel burning equipment. Check for possible backdraft
conditions on all combustion devices after installation.
5
.
NOTICE!
There are no user serviceable parts located inside the fan unit.
Do NOT attempt to open.
Return unit to the factory for service.
6.
All wiring must be performed in accordance with the National Fire Protection
Association’s (NFPA)”National Electrical Code, Standard #70”-current edition for all
commercial and industrial work, and state and local building codes. All wiring must be
performed by a qualified and licensed electrician.
7.
WARNING!
Do not leave fan unit installed on system piping without electrical power
for more than 48 hours. Fan failure could result from this non-operational storage.
Summary of Contents for GP500
Page 1: ...Page 1 of 8 IN006 Rev G ...
