7
Heater Connection Requirements
1. The heater is 220-240 volts.
2. The heater (s) are connected to a separate line with a dedicated circuit breaker with a current
cut-off rating corresponding to the power of the heater (s).
3. Consult a licensed electrician for installation.
WARNING: Do not use extension cords as they are not designed to power outdoor heaters.
Safety warnings
1. Use the heater only for its intended purpose.
2. Observe the required distances to the suspension height when installing and using the heater.
- Heater distance to ground or floor - not less than 6 feet.
- Heater distance to heated surfaces - not less than 24 inches.
3. Do not place or store flammable objects and materials in the place where the heater is used.
4. Do not touch the heater during operation, and do not allow children and pets to come into contact
with the heater.
Heater remote control
There are 3 buttons on the remote control.
Button 1 (bottom right) - power on / off.
Buttons 2 and 3 - selection of 4 heating power modes.
The selected mode is displayed on the display of the heater control module. It is
possible to control several heaters using one remote control.
Heater maintenance
• To ensure stable operation of the product, regularly inspect the heater and the supply cable for
external damage
• As the heater and reflector become dirty, clean in the following order:
1. Make sure that the heater has not been used and that the casing of the heater is at ambient
temperature.
2. Disconnect the heater from the power source, remove it from the attachment point and place it
on a horizontal surface.
3. Clean the external elements of the heater with a dry clean, soft cloth.
4. Remove the left side cover of the heater housing. There are two screws on the end of the heater
and two screws on the rear wall of the housing
5. Carefully slide the protective grill out of the left side.
6. Clean the internal elements of the compartment with a dry clean, soft cloth.
WARNING: Use cotton or latex gloves to clean. This will prevent contact with the IR element. Direct
contact with the element will leave fingerprints, which will negatively affect its operation and damage
the heating element.
7. After cleaning the heater, reassemble in the reverse order and reinstall the heater.
