Implementing External API Control
You can control the XT Codec Unit using the Scopia XT Series API (requires integration with AMX,
Creston, or Extron control devices). Contact Radvision customer support to receive the
Reference Guide
for Scopia XT Series API
, which includes the list of commands over the Ethernet interface.
Implementing Port Security for the Scopia XT Series
The Scopia XT Series provides video technology for room conferencing, including support for dual
stream 1080p video, high quality data sharing, high quality full band audio and a high-capacity
embedded MCU (selected models).
This section details the ports used for the Scopia XT Series and the relevant configuration procedures:
Navigation
•
Ports to Open on the XT Series
on page 27
•
Configuring the TCP or UDP Port Range on the Scopia XT Series
Ports to Open on the XT Series
The Scopia XT Series is typically located in the enterprise network and is connected to the DMZ. When
opening ports to and from the Scopia XT Series, use the following as a reference:
• If you are opening ports that are both to and from the XT Series, see
Table 7: Bidirectional Ports to
• If you are opening outbound ports from the XT Series, see
Table 8: Outbound Ports to Open from
on page 29.
Important:
The specific firewalls you need to open ports on depends on where your XT Series and other Scopia
Solution products are deployed.
Installation Guide for Scopia XT5000 Series Version 3.2
Planning the Topology of the Scopia XT Series Deployment | 27
