- 5 -
1. UNPACKING AND ASSEMBLING
1.1. Balance AS/X series
Cut the protective tape of balance’s factory packaging. Carefully remove the
balance from its packaging. Take out from the box all the accessories needed for
correct operation of a balance. Place the balance in its inteded place of use and
assembly its components as specified in below scheme. The balance is powered
from mains through a power adapter 13,5-16V DC.
•
Open side glass door of the weighing
chamber,
•
Inside the weighing chamber place
bottom metal plate (5),
•
Next place a centering ring (3) onto
the bottom metal plate,
•
Inside the centering ring assembly
the weighing pan (2),
•
Inside the weighing chamber and
onto the centering ring place an anti-
draft shield (1),
•
Close the side glass doors of the
weighing chamber,
•
Plug the balance to mains using the
dedicated power adapter. The power
socket for plugging the power
adapter’s pin is located at the back of
balance’s housing.
Fig. 1. Assembling components of a balance AS/X series
