- 43 -
For correct operation of the balance with AUTOTARE function it is necessary to adjust the threshold
value.
<AUTO THRES>
parameter is connected with the following functions:
•
automatic tare,
•
automatic operation,
No automatic taring takes place as long as the gross weight value stays within the range set in
<AUTO THRES>
parameter.
8.13. PRINT MODE
Function designed to enable print mode setting, it activates
key.
Print mode options:
•
<WHEN STAB>, for this option stable measurement result, along with the settings for
parameter <GLP PRINTOUT>, is sent to the printer port. On pressing
key, when the result
is not stable (no
marker on a display), the balance software sends the measurement result
to the port after reaching stability for the measurement.
•
<EACH>, for this option every single pressing of
button results with sending the
measurement indication to the printer port along with the settings for <GLP PRINTOUT>
parameter. Every single indication is sent (stable and unstable). For unstable indication <?>
character appears at the beginning of the printing frame.
This function applies to non-verified balances exclusively.
•
<AUTO> - select this option to enable automatic printing of measurements. If this option has
been selected, remember to set <AUTO THRES> parameter to suit your needs.
Automatic operation procedure:
•
Press
button to zero the balance (marker of stable measurement
and zero marker
are shown on a display)
•
Deposit load, the balance sends the first stable measurement to the printer port,
•
Remove the load from the pan,
•
Next measurement is possible when the indication is lower than the set value of <AUTO
THRES.> parameter (next measurement does not require zero value).
For automatic operation adjust the threshold value. For automatic operation, the measurement will
not be send from the computer to the printer as long as the mass measurement stays within the set
value range
<AUTO THRES>
.
<AUTO THRES>
parameter is connected with the following functions:
•
automatic tare,
•
automatic operation,
•
auto with interval.
<AUTO+INT.> select this option to start automatic printout and record of indications in Weighings
database and Alibi database, carried out in a cyclic manner in a specified time interval. The interval is
set in minutes, in parameter P2.2.3.3 <AUTO INT.>. Interval range is 1-9999 min.
CAUTION!
Each result is printed and recorded (stable and unstable for a non-verified balance, stable for a verified
balance).
Automatic operation with interval starts at the moment of switching the function on and it lasts until it is switched
off. The first stable weighing result of value greater than AUTO THRES value is printed as a first measuremnt.
The following measurements are printed with frequency set in INTERVAL parameter. Automatic operation with
interval stops when the option is off.
On switching the function of auto print with interval, PRINT button becomes inoperative (no indication is printed
when pressed).
Summary of Contents for AS X2 Series
Page 7: ...7 1 GENERAL INFORMATION 1 1 DIMENSIONS AS X2 series PS X2 series...
Page 8: ...8 APP X2 series WLC X2 series...
Page 96: ...96 Status Completed Signature...
Page 132: ...132...
