- 27 -
14. RS 232 PARAMETERS
External devices connected to RS 232C have to be supplied from the
same mains and common electric shock protection. It prevents from
appearing a potential difference between zero leads of the two devices.
This notice does not apply to the devices that do not use zero leads.
Transmission parameters:
Baud rate - 2400
– 38400 bit / s
Data bits - 7,8
Stop bits - 1,2
Parity control - no, even, odd
There are four ways of sending data via RS232 interface:
Manually
– after pressing
,
Automatically
– after stabilizing the indication over -
LO-
threshold
Continuously
– after it is activated in parameter or by a command
sent via RS232
On external request
- see -
„List of scale - computer commands”.
The indication can be sent as:
stable
–
the indication is sent after the scale stabilizes.
any
– the indication is sent immediately after pressing the
key,
this state is assign with
<?>
in the printout.
14.1. Printout type
This parameter is to select the type of printout.
Procedure:
Enter the submenu
<P2.Prnt>
and then: