11
6.8. Models
There are seven models of the MW-01-A mass converter:
MW-01-A1: standard design (RS232 + IN/OUT),
MW-01-A2: standard Ethernet,
MW-01-A3: standard RS485,
MW-01-A4: standard Profibus,
MW-01-A5: standard Profinet,
MW-01-A6: standard Ethernet IP,
MW-01-A7: standard Analog output.
7. INSTALLATION
7.1. Unpacking and Installation
A. Take the mass converter out of the packaging.
B. Connect the weighing platform to the mass converter, next place
the device on a flat and even surface. Keep it away from any sources
of heat.
C. Level the device.
Levelling procedure is to be found in 'TWM1 Scale' user
manual.
7.2. START-UP
Plug the power supply to the mains.
Wait for connection to be established between the mass converter and the
'MwManager'
software, read the weighing result.
The procedure of communication establishing and a detailed
description of connection between the scale and the
'MwManager' software is to be found in the software user
manual.
8. INSTALLER INSTRUCTION
The MW-01-A mass converter can be a base component of a load cell scale.
8.1. 6-Wire Load Cell Connection
Connect 6-wire load cell to the main board following the diagram below:
