24
10.6. PROFIBUS Module
The AB6000 module, expanding the functionality of the MW-01-A converter by
PROFIBUS interface, is installed on an intermediate board, 385R ver. A.
The module is intended to be mounted inside the MW-01-A. For the AB6000
module, an extra M12 5P connector is installed on the housing (with coding
respective for the PROFIBUS standard).
Figure 14. PROFIBUS module
10.6.1. PROFIBUS Pin Arrangement
PROFIBUS IN
(male)
Pin1
– NC
Pin2
– A
Pin3
– NC
Pin4
– B
Pin5
– NC
PROFIBUS OUT
(female)
Pin1 - +5V
Pin2
– A
Pin3
– GND
Pin4
– B
Pin5
– NC
10.7. PROFINET Module
The 494R module, combined with AB6005 module, expands the functionality
of the MW-01-A converter by Profinet interface. The module is intended to be
mounted inside the indicator. For the 494R module, a hermetic RJ45 connector
is installed on the housing.
