6
1. Remove the dirt using cloth dipped in warm water.
2. For best results, add a little bit of dishwashing detergent.
4. SERVICE AND REPAIR
In the case of any sign of damage, it is necessary
to disconnect the device from the mains immediately.
The damaged component must be replaced or repaired
by RADWAG service directly.
In the case of any problems with correct operation of the device, contact
the closest manufacturer's service point.
In the case of defects, deliver the faulty product to the manufacturer's service
point. If the product cannot be delivered to the manufacturer's service point, call
the service and report the defect. Repair scope and method will be set up.
The user is NOT ALLOWED to carry out any kind of repair
of the device himself/herself. Any attempt of module
modification, repair etc. by unauthorized persons, will result
with loss of validity of manufacturer-issued certificates,
declarations and warranty.
5. RECYCLING
The MW-01-A mass converters must be recycled, they are not to be treated as
a regular household waste. Devices to be decommissioned must be
decommissioned in accordance with valid legal regulations.
6. MECHANICAL DESIGN
The mass converter is equipped with metal housing. Depending on the
MW-01-A model, the communication with external devices is carried out via
the following communication interfaces: RS232, RS485, Ethernet, Profibus,
Profinet, Ethernet IP. The module can be equipped with 3 digital inputs,
3 analog inputs and outputs such as current loop or voltage output. It is
powered with 12÷24VDC voltage.
