RADWAG PM 4Y, Startup Manual

11. DEVICE CLEANING

Prior to cleaning it is necessary to 
disconnect the device from the mains! 
Remove the plug from the outlet, 
disconnect all cables.

Do not use aggressive cleaning 
agents (e.g. solvents, chlorine 
preparations, corrosive chemicals, 
bleach).

•  GLASS PANES AND COMPONENTS can be cleaned using window cleaner.

•  WEIGHING PANS AND STAINLESS STEEL OR ALUMINIUM COMPONENTS can be cleaned using a cloth slightly  
  soaked in a solution of water and gentle cleanser (e.g. soap or dishwashing liquid).

•  OPERATION PANEL AND HOUSING can be cleaned using a cloth slightly soaked in a solution of water and gentle  
  cleanser (e.g. soap or dishwashing liquid).

•  Dry sample leftovers can be removed using either brush or handheld vacuum cleaner.

•  Clean components can be dried using soft cloth or dust-free paper towel, with this the remaining moist will be absorbed.

•  Install all the components providing they are completely dry.

Use soft cloth made of either natural or 
synthetic fiber exclusively. Avoid using 
cloth made of stiff/hard fabric, this 
could cause scratches on the surface!

Neither use substances of sharp 
structure nor intended for 
scrubbing.

Apply the cleanser onto the cloth. Mind 
not to apply the cleanser directly onto 
the device!

Make sure that neither dust nor 
liquid gets inside the weighing 
system (device inside).

11.1. Guidelines and precautions

11.2. Cleaning instructions