- 39 -
•
Start the balance with no load on the weighing pan (permissible value of load on the weighing
pan on balance start is ±10% of its maximum capacity).
•
Load the weighing pan steadily avoiding shocks:
YES
NO
•
Place weighed loads centrally on the weighing pan:
YES
NO
•
Avoid side loading, in particular side shocks:
NO
NO
The balance requires adjusting before weighing process start or in case of drastic change of ambient
conditions at a workstation.
•
Before the start of weighing procedure, it is recommended to load the weighing pan a few times
with mass close to balance max capacity,
•
Check if unloaded balance indicates “precise zero”
and whether measurement is stable
, if not, press
/Delete
button,
•
Press
UNITS
button,
to set a measuring unit:
•
Place weighed object on the weighing pan and read result only on measurement result
stabilization,
•
Mass indication of a load placed on the weighing pan can be tared multiple number of times by
pressing
→
T
←
/Insert
(pay CAUTION not to exceed maximal capacity of a balance by applying
multiple tare function).
The balance shall stay plugged to the mains in between measurement series. It is recommended to
switch off the balance display by pressing
ON/OFF
button. On repeated
ON/OFF
button pressing, the
balance is ready for operation and carrying out the following measurements.
11.2.2. Balance Zeroing
Zeroing is a function allowing to zero mass indication. In order to zero mass indication, press
button. Mass indication of zero value shall be displayed together with precise zero
and stability
markers.
Summary of Contents for PS 200/2000 R2
Page 95: ...95...
