11
4.2. Unpacking
Carefully remove the balance from its packaging, remove the plastic and foil
wrapping and gently. Install the weighing pan, and other elements according to
below schema:
-
Take of the tape which
secures the static voltage
spring on one of the rubber
supporters (2),
-
Put on the weighing pan (1)
on the rubber supporters (3),
-
After putting on all of above
parts, please check if the
weighing pan is firmly located
on the rubber supporters.
-
Take of the tape which
secures the static voltage
spring on one of the rubber
supporters (3),
-
Put on the weighing pan (2)
on the rubber supporters,
-
Put on the glass draught
shield (1), placed on the
surface of upper casing of the
balance,
-
After putting on all of above
parts, please check if the
weighing pan is firmly located
on the rubber supporters.
Summary of Contents for PS Series
Page 2: ...2 JUNE 2008...
Page 35: ...35...
Page 48: ...48 if you want to choose one them e g 20pcs press ENTER PRINT and proceed as shown on picture...
Page 58: ...58...
