- 11 -
4.3. Leveling
Before plugging to mains, level the device using two adjusting feet
located at the back of balance’s housing. Turn the adjusting feet in a
way that the air bubble of the level is placed centrally. The level is
located at the back wall of balance’s housing.
4.4. Standard equipment
•
Balance.
•
Weighing pan and protecting (anti-draft) components.
•
Power adapter.
•
User manual on a CD.
4.5. Cleaning
Balance should be cleaned with damp cloth by gentle wiping the smudges of dirt. In
order to clean the weighing pan of the balance, it is required to remove it from the
weighing chamber.
CAUTION!!!
Cleaning of the pan when assembled may cause damage of the measuring
system of the balance.
4.6. Plugging to mains
Balance can be plugged to mains only with a power adapter that comes
standard with the balance. Nominal power supply of the power adapter
(specified on the data plate of the power adapter) should be compatible to the
power from mains
.
Plug the balance to mains – the plugging socket is located at the back of balance’s
housing. Balance display will light and show name and number of software, after
which balance will display 0.000g (for balances with resolution 1mg) or 0.00g (for
balances with resolution 10mg).
If indication is other than zero, press
ZERO/TARE
key.
Before unplugging the balance from mains it is obligatory to switch off the display
by pressing ON/OFF key on balance’s overlay.
4.7. Connecting peripheral devices
The balance must be unplugged from the mains before connecting or disconnecting
any peripheral devices (printer, PC computer). Use only peripheral devices
recommended by the manufacturer with your balance. These have been ideally
coordinated to your balance. On connecting a peripheral device, plug the balance to
mains.
Summary of Contents for PS/X series
Page 2: ...2 APRILE 2013...
