•
After scanning the code is entered to the ASCII field and HEX filed
and at the bottom of the window a test result is displayed.
When:
•
<Prefix>
and
<Suffix>
declared in settings are the same as
<Prefix>
and
<Suffix>
in the read code then the test result is
<Positive>
,
•
<Prefix>
and
<Suffix>
declared in settings are not the same as
<Prefix>
and
<Suffix>
in the read code then the test result is
<Negative>
.
16.5. Transponder card reader
Each time after turning on the device, it is possible to select (log in)
the operator using a transponder card reader and a transponder card.
Caution:
In case of problems with reading transponder cards check the submenu
<
Communication> and set appropriate baud rate (default 9600b/s).
16.5.1. Com port for transponder card readers
Procedure:
•
Enter group of parameters
<
Devices>
according to chapter 16
of this manual, select
„
Transponder cards reader
/
Port”
and set appropriate option.
The scale can communicate with the reader via following ports:
•
RS232
(1),
•
RS232
(2).
65
