Caution:
A pattern and example of the report from testing products are described in ch.
30.14 of this manual. A pattern and example of the report from estimating
average tare are described in ch. 30.13 of this manual.
30.9. Performing non-destructive testing in mode Empty-Full
For mode
„Non-destructive Empty-Full”
a user sets the measurement
“charge”
in the product data. According to the set
„charge”
a message
is shown that informs about putting empty packages first and then the
same packages after they have been filled up in the same sequence:
Where:
Product
-
Name of the controlled product
Code
-
Code of the controlled product
-
Nominal value of the controlled product
-
Average mass of the controlled product
-
Value of the disqualifying average
-
Characteristics of negative errors
T1
in a sample
(in accordance with ch. 30.6 of this manual)
-
Characteristics of negative errors
2T1
in a sample
(in accordance with ch. 30.6 of this manual)
Net
-
Net mass of the controlled product
165
