- 30 -
13. RS 232 PARAMETERS
External devices connected to RS 232C have to be supplied from the
same mains and common electric shock protection. It prevents from
appearing a potential difference between zero leads of the two devices.
This notice does not apply to the devices that do not use zero leads.
Transmission parameters:
•
Baud rate - 2400 – 38400 bit / s
•
Data bits - 7,8
•
Stop bits - 1,2
•
Parity control - no, even, odd.
There are four ways of sending data via RS232 interface:
•
Manually
– after pressing
,
•
Automatically
– after stabilizing the indication over
LO
threshold
•
Continuously
– after it is activated in parameter or by a command
sent via RS232
•
On external request
- see - „List of scale - computer commands”.
The indication can be sent as:
•
stable
–
the indication is sent after the scale stabilizes.
•
any
– the indication is sent immediately after pressing the
key, this state is assign with
<?>
in the printout.
13.1. Printout type
This parameter is to select the type of printout.
Procedure:
•
Enter the submenu
<P2.Prnt>
and then:
Summary of Contents for WPT/4
