- 41 -
no
– mode is disabled
YES
– mode is enabled
Return to weighing:
See 10.2.2.
15.2. Selecting quantity of operation modes
This function enables user to set if ,after pressing
key, all operating
modes will be accessible (
ALL
) or only one from the list chosen and
used by operator.
Procedure:
•
Enter the submenu
<P4.Func>
and then:
After choosing setting press
key. The program will return
to displaying name of submenu
<P4.1.FFun>
.
Return to weighing:
See 10.2.2.
Summary of Contents for WPT/4
