Introduction
This guide is written for using Radxa CM3 SoM with the CM3 IO board. The purpose is to learn the
details of the boards as well as how to prepare and set up for basic use.
Overview
What you need
•
Necessary
•
CM3(any variant) + CM3 IO board
•
If the CM3 doesn't have eMMC, a micro SD card larger than 8GB is required for OS
•
Power supply
o
The main PSU input (DC) is a 2.1mm DC tip po12V(only) input.
•
Monitor and HDMI Cable
o
CM3 IO board is equipped with a full sized HDMI connector. HDMI capable monitor is
recommended.
o
HDMI EDID display data is used to determine the best display resolution. On monitors
and TVs that support 1080p (or 4K) this resolution will be selected. If 1080p is not
supported the next available resolution reported by EDID will be used. This selected
mode will work with MOST but not all monitors/TVs.
•
USB to TTL serial cable
