PROGRAMMING THE AREARAE
4-5
4.3 Entering Program Mode
1. Turn on the AreaRAE monitor (press [MODE] for three
seconds and then release).
2. Press and hold [MODE] and [N/-] for three seconds to
enter Program Mode. This prevents entering Program
Mode by accident.
3. Security Level 0 or Level 2: the monitor enters Program
Mode and the first menu item “Calibrate Monitor?” will
display.
4. Security Level 1 or Text mode: “Enter Password = 0000” is
displayed with the far left digit flashing. Enter the
password, starting from the flashing digit.
Note:
Prior to factory shipment, the default password of
“0000” is programmed into the AreaRAE. For added
security, “0000” is always displayed instead of the actual
password, if you change it.
5. If the digit value is not “0,” use [Y/+] or [N/-] to increase or
decrease digit value. Press [MODE] to confirm the digit’s
value. The display shows the actual digit entered and
moves the flashing cursor to the next digit to the right.
6. Repeat Step 5 until all four digits are entered. Then press
and hold [MODE] for one second.
7. If the entered password is correct, the monitor enters the
programming menu. The first menu item, “Calibrate
Monitor?” is displayed.
8. If the password is incorrect, the display shows “Wrong
Password???” and returns to the regular display of
instantaneous sensor readings.