PROGRAMMING THE AREARAE
4-32
4.7.7 Change Password
You can modify the password from the monitor.
1. When the screen “Change Password?” appears, press
[Y/+] and the display shows the current password: “Enter
new password = xxxx” with the left-most digit flashing.
2. Press [Y/+] or [N/-] to cycle through all 10 numerals. Press
[MODE] momentarily to advance to the next digit. The
flashing digit moves to the next digit to the right. Repeat
this process until all four digits of the new password are
entered.
3. Press and hold [MODE] for 1 second to exit the data entry
mode and move to the next monitor setup submenu.
4. If there is any change to the existing password, the display
shows “Save?” Press [Y/+] to accept the new password.
Press [N/-] to discard the changes and move to the next
submenu.
5. Next, the monitor asks to confirm this value, “Confirm New
Password = 0000” with the far left digit blinking. Re-enter
the number as before to exit the Monitor Setup submenu. If
the number is not entered correctly a second time, the
password reverts to its original setting.