PROGRAMMING OF IAQRAE
4-18
4.4.2 Change Datalog Period
The datalog period can be programmed from 1 to 3,600
seconds (1 hour).
1. When the “Change Datalog Period?” screen appears,
press [Y/+], and the display “Datalog Period = 60” will
appear; “60” is the previously stored datalog period.
2. To modify this period, press [MODE] to move to the far left
digit, and use [Y/+] or [N/-] to change the value. Press
[MODE] to advance to the next digit on the right. Repeat
until all digits have been entered.
3. Press [MODE] to move the cursor to “Save?” To accept
new value and exit this submenu, press [Y/+]. To discard
the changes and move to the next submenu, press [N/-].
