ppbRAE 3000 User’s Guide
Entering Search Mode From Hygiene Mode
In order to change the instrument’s operational mode from Hygiene
Mode to Search Mode, you must enter the password-protected
Programming Mode:
1.
Hold [MODE] and [N/-] until you see the password screen.
2.
Use [Y/+] to increment to the number you want for the first
digit. (If you pass by the desired number, press [Y/+] until it
cycles through to 0 again. Then press [Y/+] until you reach
the desired number.)
3.
Press [N/-] to advance to the next digit.
4.
Again press [Y/+] to increment the number.
5.
Press [N/-] to advance to the next digit.
Continue the process until all four numbers of the password have
been input. Then press [MODE] to proceed.
The screen changes to icons with the label “Calibration.”
1.
Press [N/-] to advance to “Monitor Setup.”
2.
Press [Y/+] to select Monitor Setup.
Under Monitor Setup, you will see “Op Mode.”
Press [Y/+] to select.
You will see:
Hygiene
Search
The current mode is indicated by a dark circle within the circle in
front of either Hygiene or Search.
1.
Select Hygiene or Search by pressing [N/-].
2.
Press [Y/+] to place the instrument into the selected mode.
78
Summary of Contents for ppbRAE 3000
