OPERATION
2 - 6
To choose a specific display, press the
[MODE]
key one or
more times until the desired display appears.
Note
: To get back to “Ready” mode from any of the above
display, press the
[MODE]
key repeatedly until the
“Ready” message appears.
Figure 2-3 The UltraRAE is Ready
READY:
The monitor is ready for a measurement to be taken.
Press the [MODE] key to advance to the next menu. If a tube is
inserted at this point, the “Tube in!” message is displayed,
followed by the alternate display of the gas name and “Start?”
The [Y/+] key can be pressed to start a measurement if the
monitor does not detect the presence of
the tube
. In either
case,
the monitor will go to the second phase of the measurement
cycle (see Section 2.4.2).
LAST TUBE MEASUREMENT:
This menu displays
“Last=”, followed by the name of the last tube and the
measurement value in ppm. For example: Last = Benzene 0.0
ppm. Press the
[MODE]
key to advance to the next menu.
Ready…
