Duonet User Instructions
19
Continuous
state.
A monitored output programmed to operate as a Fire
or Fault Signal Transmission Output has been
disabled.
15
.
DAY
Amber
Flashing
Continuous
The system Day / Night mode timing has been over
ridden, and forced into the less sensitive day mode.
The system has gone in the less sensitive day mode
as programmed.
16
.
SERVICE
Amber
Flashing
The pre programmed service interval has expired
and a routine maintenance check is due.
17
.
TECHNICAL ALARM
Amber
Flashing
A device programmed as Technical Alarm is in the
alarm state and sending a Technical Alarm signal to
the panel.
18
.
ALARM
CONFIRMATION
Flashing
A smoke detector is in the alarm confirmation state,
awaiting confirmation or reset.
19
.
‘OUTPUTS DELAYED’
Amber
Continuous
An action has been started which utilises a
programmed delay.
20
.
ALARMS SILENCED
Amber
Continuous
The alarm sounders have been silenced whilst
operating, and the system is awaiting a reset.
21
.
BUZZER SILENCED
Amber
Continuous
Flashing
The control panel buzzer has been silenced whilst
operating and will stay silenced until another fault or
relevant action occurs.
The control panel buzzer has been disabled at
Access Level 3 (Engineer), and will remain silent
until it is reinstated. However, the buzzer will still
operate in the fire alarm state.
Summary of Contents for duonet
