7 / 12
Pass System Calibration
1. Make sure the airplane is set in level flying position.
2. Turn the throttle stick to min (low) position.
3. Turn on the transmitter and plug in the battery to
power on the airplane
4. Do NOT unlock the throttle at this point.
5. Hold the sticks as shown for several seconds.
6. When you hear a “beep” sound, it means the PASS
system is calibrated based on the position of the
airplane.
NOTE:
This process is only required if the model is
not performing properly when in PASS mode. Perform
this with the airplane held in a level flying position.
The stunt button allows the pilot to perform a roll
or loop automatically when flying in either PASS
assist mode. As shown in the below diagrams,
while flying in either mode, press the one-key
stunt button on the left shoulder of the transmitter
and you will hear several beeps. While the
transmitter is beeping, simply move the aileron
stick to either direction for auto-roll or move
the elevator stick to up elevator (stick down) to
perform a loop.
One-key
Stunt Button
Stunt Function Button
