4
Battery Installation
Connect the leads from the battery and the drone. Fit
the leads and connectors into the drone, then slide the
battery into position.
Fit the battery cover tabs into the slots near the center of
the body. You will need to start at an angle and twist the
cover slightly to snap the tabs into place.
Close the battery cover by sliding it into position.
Flight Preparation
Rest the drone on the landing gear on a level surface.
Switch the power button on the bottom of the drone to
the ON position. The LED lights on the drone will flash
rapidly.
Next, turn on the transmitter. The LED lights on the drone
will flash slowly once the transmitter and drone connect
to each other.
Arming for Flight
Once the drone and transmitter connect you can then
arm the drone for flight. Move the left stick (throttle) up
slowly until the drone beeps. Move the stick down until
the drone beeps again. Your drone is now ready for flight.
1
2
Once the drone has been armed, the LED lights will glow
solid indicating it is ready for takeoff.
Auto Take-Off and Auto Landing
Press the trim lever next to the throttle stick up. The
drone will then rise to a height of roughly 3 feet (1 meter)
to begin its flight.
Pressing the trim lever next to the throttle stick down will
enter landing mode. The power will quickly decrease and
stop the motors once the drone has landed safely.