Chapter 2 Hardware Installation
Figure 2-16: Drive Tray Front Flap
Step 3.
Line the drive tray up with the slot
in which you wish to insert it.
Make sure that it is resting on the rails inside the enclosure. Once
the drive tray is lined up with the slot, gently slide it in. This
should be done smoothly and gently.
Step 4.
Close the front flap on the drive tray
. Make sure the front flap is
closed properly to ensure that the connector at the back of the
drive tray is firmly connected to the corresponding connector on
the backplane. If the front flap is not closed properly, the
connection between the hard drive and the subsystem will not be
secure.
Figure 2-17: Installing a Drive Tray
Step 5.
Lock the flap into place.
Use a flathead screwdriver to turn the
key-lock until the groove on its face is in a vertical orientation.
(See
Figure
2-18
)
Drive Tray Installation
2-17
