(4) Setting method specification
Setting method specification selects the initialization method.
Figure 11.1.7 Setting Method Specification Screen
The initialization wizard provides the following two methods.
Individual setting
Do not use the “initialize wizard file” but make settings by following the wizard hereafter.
Batch setting with initialize wizard file
Batch initialization can be performed by using an initialize wizard file prepared in advance.
An “initialize wizard file” may have been created if another disk array was initialized
previously.
Refer to (12)
“Setup completion” regarding saving the initialize wizard file.
Pay heed to the following points when using an initialize wizard file.
Use it for disk arrays of the same configuration.
Use it after editing the IP address and license key.
Do not edit other parameters, but make any changes to their settings from
“Configuration Setting” after initialization ends.
Since path information in an LD Set is information for the server that was used
when the initialize wizard file was saved, confirm or modify it by manipulating
Access Control in “Configuration Setting” after initialization ends if a different
server is being used.
-
87
-
Summary of Contents for Xanadu
