12
www.raider.bg
For convenience in the set there is an empty oiler with a volume of 100ml.
The oil can also be poured into the oil pan by cutting off the top and pouring it into the hammer.
The oil level must be checked before each start-up.
In a horizontal position, the level should be 3 to 5 mm.
The oil should be changed every 40-50 hours or every year.
Check accessory holder / work tool.
The holder may become loose due to excessive use.
Maintain the motor
- brush replacement
- accessories. In case of wear - replace.
Check mounting screws
Check all mounting screws regularly and make sure they are properly tightened.
If any of the screws loosen, tighten them immediately. If you don’t, you can
lead to serious danger.
6. Check the accessory
The accessory may become loose due to excessive use. Always pay attention to the retainer to hold the
accessory. If wear is found, hand it in to an authorized service center.
7. Motor maintenance
Make sure that the coil is not damaged and / or wetted with oil or water.
8. Check the carbon brushes
The motor uses carbon brushes, which are consumables. When worn
or near the “wear limit”, this leads to engine problems. Make sure that the carbon brushes move freely.
9. Replacement procedure
the procedure must be performed by an authorized Raider service center.
10. Environmental protection.
In order to protect the environment, the power tool, accessories and packaging must be properly recycled
for the reuse of the valuable raw materials they contain.
Do not dispose of power tools with household waste! According to EU Directive 2012/19 / EC on end-of-
life electrical and electronic devices and the endorsement and national law, power tools that can no longer
be used must be collected separately and subjected to appropriate processing to utilize the are in them
valuable raw materials.
Summary of Contents for 013137
Page 33: ...33 ...
Page 69: ...69 EXPLODED VIEW OF RD DH02 ...
Page 85: ...85 ...
Page 91: ...91 ...
