7
c. Installation of Twin Engines
When installing two outboard engines, be sure to keep an interval of 470 to 600 mm (18 to
26 inches) between the two engines. Both outboard engines should be at the exact center
of the stern and mount it against the Rubber Inflatable Boat pad or plate. It is important to
keep it centered as much as possible, after centering on transom tighten clamp screws of
both motors by hand. The attachment of a single steering unit for dual mount assembly can
be quickly placed on dual motors for control and a cable inserted from one engine to the op-
posite for single power to both outboards.
d. Installation of Safety Wire
To prevent loss of engine (engines) overboard, attach engine retention
cable that is attached to the Raider outboard to the boat.
e. Transom Height
The Raider has been designed to have the anti-ventilation plate at a level 10 to 30 mm (0.4 to
1.2 inches) below the bottom of the boat as shown above. Be sure the anti-ventilation plate of
the Rader outboard is below the water surface when running with wide open throttle.
18 to 26 inches apart
CAUTION
Overheating may occur if Anti-ventilation plate is at
higher level than the boat as a lack of cooling water.
