30
www.raider.bg
•
When removing the cutting blade for sharpening or replacement. Protect your hands with a
pair of heavy gloves or use a heavy rag to hold the blade.
•
Remove the bolt and the washer that hold the blade and the blade adapter to the engine
crankshaft.
•
Remove the blade and the adapter from the crankshaft.
WARNING: periodically inspect the blade adapter for cracks, especially if you strike a
foreign object. Replace when necessary.
When sharpening the blade, follow the original angle of grind as guide. It is extremely important
that each cutting edge receives an equal amount of grinding to prevent an unbalanced blade. An
unbalanced blade will cause excessive vibration when rotating at high speeds. It may cause damage
to the mower and could break causing personal injury.
The blade can be tested by balancing it on a round shaft screwdriver. Remove metal from the
heavy side until it balances evenly. It is recommended that the blade always be removed from the
adapter when testing for balance. Before reinstalling the blade and the blade adapter to the unit,
lubricate the engine crankshaft and the inner surface of the blade adapter with light oil.
•
Be sure to install the blade with the side of the blade marked with part number facing the
ground when the mower is in the operating position.
•
Slide the blade adapter on to the engine crankshaft.
•
Place the blade on the adapter. Be certain the blade is aligned with and seated on the blade
adapter flanges.
•
Place washer on blade. Make sure the notches on the blade bell support are aligned with
the small holes in the blade.
•
Replace hex bolt.
•
Tighten hex bolt to torque: 45-50 Nm (33-36ft.lb).
•
Three disc bolts: 9-11 Nm (6.6-8ft.lb).
•
Tip mounting bolt: 20-25Nm (15-18ft.lb).
NOTE: to ensure safe operation of your mower. The blade bolt must be checked periodically for
correct torque.
Note: If the machinery used in the process have any questions, please contact with dealers,
professional maintenance staff to carry out repairs. Prohibited demolition machinery.
SECTION 8: LUBRICATION
WARNING: always stop engine and disconnect spark plug wire before cleaning Lubricating or
doing any kind of service work on the lawn mower.
Summary of Contents for Garden Tools RD-GLM10
Page 90: ...90 www raider bg EXPLODED VIEW AND SPARE PARTS LIST EXPLODED VIEW AND SPARE PARTS LIST ...
Page 101: ......
Page 106: ...106 www raider bg ...