41
80W-90. Select the SAE oil viscosity level to match the temperature conditions at the place of use
X
DON‘T MIX OILS!
Quantity should be accurately dosed according to specifications.
6. Turn off the engine.
7. Turn off the candle.
8. Unscrew and remove the gearbox oil filler plug with a suitable tool (FIG. 10A).
9. Carefully top up the gearbox oil. Do not spill!
10. Tighten the gearbox oil filler plug again.
PREPARATION OF THE MOWER
ADJUSTMENT OF STEERING HEIGHT
X
Slightly loosen the bolts (Fig. 11A) with the ring and washer on both sides of the handlebar holder (Fig. 11B).
X
Set the desired steering height.
X
Tighten the bolts with the ring and washer again.
MOWER
X
For the mower to function properly, it is necessary to take care of the mowing hair. Adjust and care for the
bus according to the MAINTENANCE / Adjustment and Maintenance section of the mower.
X
On a new machine, check the trim strip adjustment after the first hour of operation
WORK
THE ENGINE PRODUCES CARBON MONOXIDE DURING OPERATION. IT IS A COLORLESS,
ODORLESS POISON GAS. BREATHING CARBON MONOXIDE CAN CAUSE NAUSEA, FATIGUE,
REPRODUCTIVE DISORDERS OR EVEN DEATH.
TO START THE ENGINE
1. The ignition is carried out through the cable and the spark plug cap (rubber shoe) with the spark plug. Check the
connection (Fig. 12A).
2. When starting a cold engine, turn the throttle valve lever (Fig. 13A) to „b START“. When starting a warm engine, turn
the throttle lever to FAST „c“.
3. Press the lamp button (Fig. 12B) 3 times before starting the engine. Priming is usually unnecessary when restarting
a warm engine.
4. Grasp the starter handle (Fig. 14A) and gently pull the starter handle until it starts to stand, then pull it up quickly and
firmly.
Do not allow the starter handle to slide back against the engine.
Return it carefully to prevent damage to the starter.
Quickly pulling the starter cord (pullback) will pull the arm closer to the motor than you can start.
Broken bones, fractures, bruises or sprains can occur.
5. Return the starter handle slowly to the rope guide bolt after starting the engine.
6. When the engine is started, pull the throttle lever to position „c“. Wait until the engine speed is stable before each lever
motion. Operate engine with throttle lever in „c“ position.
7. Use the „SLOW“ position „d“ for idle only.
Do not tilt the mower when starting the engine. Start the mower on a level surface without tall grass
or obstacles.
Summary of Contents for GARDEN TOOLS RD-SBM01
