15
INTEND USE
Coating Materials Suitable for Use
Water- and solvent-based paints, finishes, primers, 2-component paints, clear finishes, automotive
finishes, staining sealers and wood sealer-preservatives.
Coating Materials Not Suitable for Use
Wall paints (emulsion paints) etc., alkali and acidic paints.
Wear hearing protection while operating the power tool
.
The declared vibration total value has been measured in accordance with a standard test
method and may be used for comparing one tool with another.
The declared vibration total value may also be used in a preliminary assessment of exposure.
WARNING
The vibration emission during actual use of the power tool can differ from the declared total value
depending on the ways in which the tool is used.
There is the need to identify safety measures to protect the operator that are based on an
estimation of exposure in the actual conditions of use (taking account of all parts of the operating
cycle such as the times when the tool is switched off and when it is running idle in addition to the
trigger time).
U
SE
1. PREPARING THE COATING MATERIAL
The paints usually need to be diluted for use with the spray gun. Since information on sprayable
dilutions is seldom given on the material tin, you can use the guidelines in the viscosity table on the
following page (viscosity = consistency of the coating material).
Measuring the Viscosity
1. Stir the coating material thoroughly before measuring.
2. Dip the viscosity test cup completely into the coating material.
3. Hold the test cup up and measure the time in seconds until the liquid empties out.
Note: This time is called
“Runout Time in Seconds”
.
Viscosity table
Primers
25-50
Clear varnishes
15-40
Solvent containing gloss paints
15-50
Water-dilutable gloss paints
20-40
Wood presevatives
undiluted
2 component paints
20-50
Motor-vehicle enamels
20-40
2. START-UP
Before connecting to the mains supply, be sure that the supply voltage is identical with the value
given on the rating plate.
1. Mounting air hose.
Insert the air hose tightly in connections on the machine
and the spray gun (a + b). The connections can be positioned as desired.
2. Unscrew the container from the spray gun.
3. Aligning suction tube. The container contents are to be
sprayed out almost completely. When spraying horizontal surfaces, turn suction tube forward (A).
When spraying objects overhead, turn suction tube back (B).
Summary of Contents for Pro RDP-SGC08PRO
