13
Maintenance and cleaning work on the machine as well as removal of the safety devices may only be performed when the motor
is switched off and the power cable has been pulled.
7.1 CLEANING
• Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible.Wipe the equipment with a
clean cloth or blow it with compressed air at low pressure.
• We recommend that you clean the device immediately each time you have finished using it.
• Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could
attack the plastic parts of the equipment. Ensure that no water can seep into the device.
7.2 REPLACE THE HOE BLADES
For safety reasons, we recommend having the hoe blades replaced by an authorized professional (see address on warranty
certificate).
Important!
Wear working gloves. Use only genuine spare parts since otherwise the function and safety of the machine cannot be
guaranteed.
7.3 MAINTENANCE
Ensure that all mounting components (i.e. screws, bolts, nuts etc.) are always tightened so that the machine can be safely
operated at all times.
Store the device in a dry room. All the metal parts should be cleaned and then oil to ensure that they provide a long life. For best
results, clean the plastic parts of the machine with a brush or rag. Do not use any solvents to remove dirt.
At the end of the season, perform a general inspection of the machine and remove any deposits which may have accumulated.
At the start of each season, ensure that you check the condition of the machine. If repairs are necessary, please contact one of our
customer service centers (see address on warranty certificate).
7.4 ORDERING REPLACEMENT PARTS
Please quote the following data when ordering replacement parts:
• Type of machine
• Article number of the machine
• Identification number of the machine
• Replacement part number of the part required
8. DISPOSAL AND RECYCLING
The unit is located in the packaging to avoid damage during transit. This pack is the raw material can be used
again and can be returned and can be returned into the cycle of the secondary surovini.Uredat and accessories
are made of different materials such as metal and plastics. If after prolonged use your machine needs replacing ,
do not throw away the old case of household waste , and destroy it in a way that is safe for the environment.
Waste electrical products should not be disposed of with household waste. Please find out where there are
opportunities to recycle. Ask local authorities or dealer advice on recycling.
9. TROUBLESHOOTING GUIDE
Fault
Possible causes
Remedy
Motor does not start
a) No power at the plug
b) Cable defective
c) Switch/plug block defective
d) Motor terminals or capacitor
disconnected
e) excessive working depth
a) Check the power cable and
fuse
b) Check
c) By customer service
workshop
d) By customer service
workshop
e) Reduce working depth
Motor performance drops
a) Soil too hard
b) Blades badly worn
a) Correct working depth
b) Replace hoe blades
Important note!
For protection, the motor is equipped with a thermal switch which cuts out when the motor is overloaded and switches on again
automatically after a short cooling period.
