30
www.raider.bg
place and working.
8.
Never run an engine indoors or in a poorly ventilated area. Engine exhaust contains carbon
monoxide, an odorless and deadly gas.
9.
Do not operate machine while under the influence of alcohol or drugs.
10.
Exercise extreme caution when operating on or crossing gravel surfaces. Stay alert for
hidden hazards or traffic.
11.
Exercise caution when changing direction and while operating on slopes.
12.
Plan your snow-throwing pattern to avoid discharging towards windows, walls, cars etc.
Thus, avoiding possible property damage or personal injury caused by a ricochet.
13.
Never direct the discharge toward people or areas where property damage can occur. Keep
children and others away.
14.
Do not overload machine capacity by attempting to clear snow at too fast of a rate.
15.
Never operate this machine without good visibility or light. Always be sure of your footing
and keep a firm hold on the handles. Walk, never run.
16.
Disengage power to the auger/impeller when transporting or not in use.
17.
Never operate machine at high transport speeds on slippery surfaces. Look down and
behind and use care when backing up.
18.
If the machines should start to vibrate abnormally, stop the engine, disconnect the spark
plug wire and ground it against the engine. Inspect thoroughly for damage. Repair any damage before
starting and operating.
19.
Disengage all control levers and stop engine before you leave the operating position(behind
the handles). Wait until the auger/impeller comes to a complete stop before unclogging the chute
assembly, making any adjustments, or inspections.
20.
Never put your hand in the discharge or collector openings. Always use the clean-out tool
provided to unclog the discharge opening. Do not unclog chute assembly while engine is running.
Shut off engine and remain behind handles until all moving parts have stopped before unclogging.
21.
Use only attachments and accessories approved by the manufacturer (e.g. wheel weights,
tire chins, cabs etc.).
22.
Never touch a hot engine or muffler
23.
If situations occur which are not covered in this manual, use care and good judgment.
Contact your Service Center for assistance.
Functional description and purpose
This machine is designed to clean fresh snow on playgrounds, areas around houses, sidewalks,
parking lots, courtyards, paths, alleys, gardens and more. In accordance with the safety instructions
provided in this operating manual, the use of snowthrower for other purposes is considered to be
unsuitable and the manufacturer assumes no responsibility for any damages and damage incurred.
Making changes to the design of the machine on its own initiative relieves the manufacturer of any
liability for damage. Work with the machine is related to the possibility of injury and damage to third
parties and their property located in the work area.
Clearing a Clogged Discharge Chute
Hand contact with the rotating impeller inside the discharge chute is the most common cause of injury
associated with snow throwers. Never use your hand to clean out the discharge chute.
To clear the chute:
1. SHUT THE ENGINE OFF!
2. Wait 10 seconds to be sure the impeller blades have stopped rotating.
3. Always use a clean-out tool, not your hands.
Do not modify engine
To avoid serious injury or death, do not modify engine in any way. Tampering with the governor setting
can lead to a runaway engine and cause it to operate at unsafe speeds. Never tamper with factory.
Summary of Contents for RD-GST04
