32
www.raider.bg
3. Assemble the gear control rod:
1) pull out the control rod (fig.4 A) out from the dashboard.
2) insert the angle side (fig.4 B) of control rod into the hole on the lever (fig.4 C) to connect it to the
transmission, and secure it in place with the B pin.
3) bring the other side of the control rod to the hole on the bottom part of the gear lever (fig.4 D) , and
secure it in place with the B pin.
4. Assemble the control handles
Assemble the control handles to the panel. Bigger one for gear control, and smaller one for chute cap
control.
Fig. 5
A
B
C
D
A
B
A
B
Fig. 6
Fig. 7
Fig.8
В
А
Fig.9
В
А
Fig.10
5. Assemble the chute
1) Take out the chute, chute connecting bar.
2) Put chute to the machine, let chute end (fig.6 D) to the right
position on chute seat (fig.7 B). Make sure the chute support bar
(fig.6 C) is inserted into the seat (fig.7 A).
3) Fix the chute support bar (fig.6 C) to the seat (fig.7 A) by two
bolts and nuts.
4) Insert the chute bar’s end A (fig.8 A) to the hole in the panel,
then connect the other end B (fig.8 B) with point A (fig.6 A) on
the chute. And fix them with bolts.
5) See chute cap control cable’s end B on fig.10. Release the
two nuts on the cable end as show in fig.10 A. Put fig.10 A to
fig.9 A, fig.10 B to fig.9 B. Then screw tight the two nuts on the
cable to fix it in the panel.
Summary of Contents for RD-GST04
