34
www.raider.bg
Clean-Out Tool
WARNING: Never use your hands to clear a clogged chute assembly. Shut off engine and remain behind
handles until all moving parts have stopped before unclogging.
The chute clean-out tool is fastened to the top of the auger housing with a mounting clip. The tool is
designed to clear a clogged chute assembly.
Operation with snow thrower
Skid Shoes
Position the skid shoes based on surface conditions. Adjust upward for hard-packed snow. Adjust
downward when operating on gravel or crushed rock surfaces.
Recoil Starter Handle
This handle is used to manually start the engine.
Electric Starter Outlet
Requires the use of a two-prong outdoor extension cord and a 230V/110V power source.
NOTE: This machine is not equipped with an extension cord.
Augers
When engaged, the augers rotate and draw snow into the auger housing.
Chute
Snow drawn into the auger housing is discharged out the chute assembly.
Gas Cap
Unthread the gas cap to add gasoline to the fuel tank.
Oil Fill
Engine oil level can be checked and oil added through the oil fill!
Before Starting Engine
Do not start the engine until filled with oil. The engine can be seriously
damaged without oil .
1.
Place the machine on a level floor.
2.
Loosen the dipstick and read the oil level. See fig 17
3.
The oil level shall be between the marks “HIGH” and “LOW”.
See fig 17
4.
It necessary fill with oil up to the FULL mark .See fig.17.
5.
Use good quality oil marked A.P.I. service SF, SG or SH.
Use SAE 5W30 oil. Use SAE OW30 oil for temperatures under -18
0
C
Do not use SAE 10W40.
Gasoline
WARNING: Use extreme care when handling gasoline is extremely flammable and the vapors are
explosive. Never fuel the machine indoors or while the engine is hot or running. Extinguish cigarettes,
cigars ,pipes and other sources of ignition.
Store gasoline in a clean, approved container and keep the cap in place on the container.
Make sure that the container form which you pour the gasoline is clean and free from rust or
other foreign particles.
Operating your snow thrower
NOTE: A plastic dust cap may be found inside the fuel fill opening.
Remove and discard, if present.
Always fill the fuel tank outdoors and use a funnel or spout to prevent spilling.
Fill fuel tank with clean, fresh, unleaded gasoline.
Never fill the fuel tank completely. Fill the tank to within 1/2” from the top to provide space for
expansion of fuel.
place. Do not attempt to turn the key.
NOTE : The engine cannot start without the key is fully inserted into the ignition switch.
not certain.
Fig.17
Summary of Contents for RD-GST04
