36
www.raider.bg
seconds. The noise made in the starter is normal. The engine’s starter is not being harmed.
3.
When disconnecting the extension cord, always unplug the end at the wall outlet before
unplugging the opposite end from the snow thrower.
4.
Move throttle control to OFF position.
5.
Remove the ignition key and store in a safe place.
6.
Wipe all snow and moisture from the area around the engine as well as the area in and around
the drive control and auger control. Also, engage and release both controls several times.
Recoil Starter
1.
With engine running, pull the starter rope with a rapid, continuous full arm stroke three or four
times. Pulling the starter rope will produce a loud clattering sound, which is not harmful to engine.
2.
Move the throttle control to OFF position.
3.
Remove the ignition key and store in a safe place.
4.
Wipe all snow and moisture form the area around the engine as well as the area in and around
the drive control several times
Chute Clean-Out Tool
The chute clean-out tool is conveniently fastened to the rear of the auger housing with a mounting clip.
Should snow and ice become clogged in the chute assembly during operation, proceed as follows to safely
clean the chute assembly and chute opening.
1.
Release both the Auger Control and the Drive Control.
2.
Stop the engine by removing the ignition key.
3.
Remove the clean-out tool from the clip which secures it to the rear of the auger housing. .
WARNING: The muffler, engine and surrounding areas become hot and can cause a burn. DO not touch.
4.
Use the shovel-shaped end of the clean-out tool to dislodge and scoop any sow and ice which
has formed in and near the chute assembly.
5.
Refasten the clean-out tool to the mounting clip on the rear of the auger housing, reinsert the
ignition key and start the snow thrower’s engine.
6.
While standing in the operator’s position (behind the snow thrower), engage the auger control for
a few seconds to clear any remaining snow and ice from the chute assembly.
To Engage Drive
1.
With the throttle control in the Fast (rabbit) position, move shift lever into one of the four
forward(F) positions or the reverse (R) position. Select a speed appropriate for the snow conditions and a
pace you’re comfortable with.
NOTE: When selecting a Drive Speed, use the slower speeds until you are comfortable and familiar with
the operation of the snow thrower.
2.
Squeeze the auger control against the handle and the auger will turn. Release it and the augers
will stop.
3.
Squeeze the drive control against the handle and snow thrower will move. Release it and drive
motion will stop.
IMPORTANT: NEVER reposition the shift lever (change speeds or direction of travel) without first releasing
the drive control and bringing the snow thrower to a complete stop. Doing so will result in premature wear
to the snow thrower’s drive system.
Maintanance. Lubrication.
WARNING: Before lubricating, repairing, or inspecting, disengage all controls and stop engine. Wait
until all moving parts have come to a complete stop.
Gear Shaft
The gear (hex) shaft should be lubricated at least once a season or after every 25 hours of
operation.
1.
Remove the lower frame cover by removing the two screws which secure it.
2.
Apply a light coating of an all-weather multi-purpose grease to the hex shaft. See Figure
18.
IMPORTANT: Avoid oil spillage on rubber friction wheel and aluminum drive plate.
Summary of Contents for RD-GST04
