38
www.raider.bg
3.
Roll the auger belt off the engine pulley. See Figure
23.
4.
Loosen and remove the shoulder screw which acts as
a belt keeper.
Unhook the support bracket spring from the frame. See Figure
24.
5.
Remove the belt from around the auger pulley, and
slip the belt between the support bracket and the auger pulley.
Reassemble auger belt by following instructions in reverse
order.See Figure 25.
NOTE: Do NOT forget to reinstall the shoulder screw and
reconnect the spring to the frame after installing a replacement
auger belt.
Augers
The auger are secured to the spiral shaft with two
shear pins and cotter pins. If the auger should strike a foreign
object or ice jam, the snow thrower is designed so that the pins
may shear. See Figure 26.
If the augers will not turn, check to see if the pins
have sheared. One set of replacement shear pins has been
provided with the snow thrower. When replacing pins, spray an
oil lubricant into shaft before inserting new pins.
Drive Belt Replacement
To remove and replace your snow thrower’s auger belt, proceed
as follows:
1.
Remove the belt cover in the front of the engine by
removing the two self-tapping screws. See Figure 27.
NOTE: Drain the gasoline from the snow thrower or place a
piece of plastic under the gas cap.
2.
Carefully pivot the snow thrower up and forward so
that it rests on the auger housing. Remove the frame cover from
the underside of the snow thrower by removing four self-tapping
screws which secure it. See Figure 28
Fig.23
Fig.24
Fig.25
Fig.26
Fig.28
Fig.27
Summary of Contents for RD-GST04
