11
1.4.3. Disconnect the plug from the power source and/or the battery pack from the power tool before
making any adjustments, changing accessories, or storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
1.4.4. Store idle power tools out of the reach of children and do not allow persons unfamiliar with the
power tool or these instructions to operate the power tool. Power tools are dangerous in the hands of
untrained users.
1.4.5. Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts
and any other condition that may affect the power tool’s operation. If damaged, have the power tool
repaired before use. Many accidents are caused by poorly maintained power tools.
1.4.6. Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
1.4.7. Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking
into account the working conditions and the work to be performed. Use of the power tool for operations
different from those intended could result in a hazardous situation.
2. ADDITIONAL SAFETY MEASURES
Be extremely careful about hidden under plaster electrical lines, plumbing or gas pipes. Always check
the work area (possibly with a metal detector).
WARNING! Do not carry MACHINE holding it by the power cord or GRIP!
OPERATING INSTRUCTIONS
REPLACEMENT of the nozzle.
Attention! Whenever replacing a nozzle check whether Dust cap is not damaged and is in place,
otherwise contact your dedicated service.
SDS system is designed to grip more easily and more rapidly changing operating ends of the machine
(chisels, drills, etc.). Drill bits are automatically centered at work, this does not affect the accuracy of the
breach.
WARNING! NEVER USE OTHER THAN THE SYSTEM TERMINALS SDS - PLUS FREE outlined for
this purpose chuck (SDS-PLUS TO CONVENTIONAL)!
3. Insert the tip (not included). Clean carefully tip side contact with the machine, then promazhete with
lubricant (it is necessary to reduce friction at work). Get back on the grip release mechanism. Place the
mouthpiece in the mouth of grip and rotate it slightly until the drill bit “sink” into a smooth grip. Nozzle lock
automatically after a release mechanism to return to the starting position.
