13
11. Depth.
With the help of depth akutratno can adjust the depth of the bores.
12. Modes of operation.
WARNING! NEVER change the behavior AT WORK THE MACHINE!
- Mode “Hammer drilling”
Press the release button and turn the switch operating modes into position
(fig.1)
- Mode “Drilling”
Press the release button and turn the switch operating modes into position
(fig. 2)
13. Sharpening chisels.
Sharp chisels ensure fast and smooth operation. It is desirable to sharpen chisels on the grinder
periodically in a scheme described in the figure:
14. Replacing the wiper
Replacement of the wiper is a manipulation that can be done freely by the user, but if you perform a
similar operation for the first time - do not hesitate to contact
authorized service center to receive further instructions and help.
Periodically check on godnosta interacted brushes. To do this unscrew brush caps (poz.9). Check the
surface of the brush if it is dirty or damaged or - replace brushes if you notice traces of soot - contact an
authorized service center.
WARNING! Always replace wiper only model with the same brush that is designed and equipped!
After replacing with new wiper necessarily leave the machine to work about 15 minutes without load!
WARNING!
For longer technical life of your machine, follow the instructions of the manufacturer.
Before working note of the technical characteristics of the instrument and instructions for use.
15. Maintenance and Service.
15.1. Maintenance and Cleaning.
Before any work on the machine itself, pull the mains plug.
For safe and proper working, always keep the machine and ventilation slots clean.
In extreme conditions, always use dust extraction as far as possible. Blow out ventilation slots
frequently and install a residual current device (RCD). When working metals, conductive dust can settle
in the interior of the power tool. The total insulation of the power tool can be impaired.
