14
www.raider.bg
battery.
- All LEDs illuminated: The battery is fully charged.
- Yellow and red LED illuminated: The battery has an adequate remaining charge.
- Red LED: The battery is empty, recharge the battery.
USB Power Port
You can power any portable device that uses a USB power port (10). The output is 5 volts at
1.5 mA
maximum output. You cannot charge the battery using this port, it is for output power only.
Charging port
You can also charge the battery through the modular charging port (10). The input is
a maximum of 13v at 1.5 mA. This will take approximately 1.5 hours at maximum input. This
adapter is not included.
LED lamp
The LED lamp (7) can be used in poor lighting conditions to illuminate the work area. The LED
lamp will light up as soon as you press the trigger (6).
5. Operating the tool
To activate the tool, press the Trigger (6) and keep it pressed. To switch off the machine,
release the trigger. The trigger is variable speed and the speed depends on the amount of
pressure you apply to the trigger. Light pressure on the trigger results in a low rotational speed.
Further pressure on the switch results in an increase in speed.
5.1. Forward (clockwise) operation:
The motor has an electronic clutch with three different forward speed settings: 1, 2, and 3 (low,
medium and high). The speed setting is adjusted by pushing the ″S″ button on the Electronic
clutch control panel (5) on the base of the tool. If the trigger is momentarily pushed the Electronic
Clutch will be activated.
If one green LED is illuminated, the motor is set to Speed 1. If two green LEDs are illuminated
then the motor is set to speed 2 and three green LEDs for speed 3. Push the button marked ″S″
on the Electronic clutch control panel to cycle through the three speed settings and select the
correct one for your specific application.
speed
RPM
IPM
Working torque
Max. tourque
1st speed
0-1600
0-1800
220
275
2 nd speed
0-2000
0-2500
276
345
3 rd speed
0-2600
0-3300
320
400
Reverse
0-2600
0-3300
320
400
5.2. Reverse (counter clockwise) operation:
The electronic clutch has two different reverse modes: Full Reverse and Auto Break.
The Full Reverse mode is automatically activated when the direction switch (2) is put into the
reverse position. No LEDs on the Electronic clutch control panel should be illuminated. This
means that the clutch is set to full reverse mode. When the trigger is pushed the tool will
operate in reverse for as long as you hold down the trigger.
The Auto Break function is engaged by pushing the ″B″ button on the Electronic clutch control
panel (5). A red LED will illuminate in the third LED position to indicate that the Auto Break is
engaged. When the trigger is pushed the tool will start hammering in reverse. As soon as
the bolt breaks loose and there is no resistance the tool will immediately stop reverse motion.
This feature is meant for controlled loosening of lug nuts without backing fully off the stud.
Uncontrolled spinning can damage the treads on the end of the stud or bolt. To disengage break
just push the ″B″ button one more time and the red LED will turn off. Your tool is again in the full
reverse mode.
NOTICE: Both reverse functions only operate with the electronic clutch in the third speed
position.
This feature is unavailable in speed one and two.
Summary of Contents for RDI-IBW01
Page 91: ...91 EXPLODED VIEW AND SPARE PARTS LIST ...
Page 92: ...92 www raider bg ...
Page 108: ...108 www raider bg ...
Page 113: ...113 ...
