14
www.raider.bg
cutting blade has completely stopped.
● Remove the plug from power supply after
use. Empty the water tray, clean the machine
and pump. Lock the sliding table before
maintenance, transportation or storage.
5. Filling the Water
● Fill the water tray with clean water. Do
not add chemicals or detergents to the water.
Make sure the pump is well below the water
level.
● Water can be added or refilled as needed
during the operation of the machine.
6. Straight Cutting
● Loosen the screw knob of the mitre
gauge.
● Fit the mitre gauge onto the left side
fence at the back edge of the table.
● Set the mitre gauge to the desired size
using the embossed ruler guide.
● Relock the screw knob.
● Position the tile against the fence of
the table and against the mitre gauge when
cutting.
7. Using the Extension Bracket
● The extension bracket can be used
to give additional support for larger tiles if
necessary.
● Pull out the extension bracket on the
left side of the sliding table to the distance
required, but do not remove it from the sliding
table.
● Tighten the two knobs on both rods to
lock in place.
● Move the side stop upwards.
● Place the tile against the fence of the
sliding table and the side stop of the extension
bracket when cutting.
8. Changing the Blade
● WARNING! To avoid injury from
accidental starting, always turn the switch
off “O” and remove the power plug from the
power source before changing the blade.
● Open the access cover of the blade
guard by removing the two securing screws.
● Remove the locking arbor bolt using the
hexagonal spanner while holding the outer
flange in place with the holding spanner
● Remove the outer flange, then the saw
blade
● When fitting the new blade, the rotational
arrow on the blade must point in the same
direction as that marked on the blade cover.
● Inspect the new saw blade for visible
damage. In the event it is damaged, replace
it immediately.
● Re-fit the outer flange, and then tighten
the locking arbor bolt firmly using spanners.
● Re-fit the access cover of the blade
guard.
Note: Use only 300x25.4mm wet type or
turbo type blades specifically designed for
tile cutting. Do not use any blade rated for
less than 2950 rpm.
9. Functions and characteristics
The mitre gauge on the table can turn
to any angle between 0º to 45º for diagonal
cutting. In the process of cutting, the pump
will provide the blade with water which can
help to extend the life of the blade and also
reduce dust.
