13
the use of additional tools.
Insert the SDS-max quick. Clean and lightly grease the shank end of the tool. Insert the tool
in a twisting manner into the tool holder until it latches itself. Check the latching by pulling the
tool. As a requirement of the system, the SDS-max drilling tool can move freely. This causes
a certain radial run-out at no-load, which has no effect on the accuracy of the drill hole, as the
drill bit centres itself upon drilling.
The dust protection cap (4) largely prevents the entry of drilling dust into the tool holder
during operation. When inserting the tool, take care that the dust protection cap (4) is not
damaged.
4.3. Removing SDS-max drilling tools. Push back the locking sleeve (5) and remove the tool.
5. Inclusion and exclusion. Beware of the voltage of supply network! Supply voltage of the
network must conform to the details shown on the plate of power. Appliances marked with 230
V, can be supplied with a voltage of 220 V.
5.1. To start the machine, press the On/Off switch (1).
5.2. To switch off the machine, release the On/Off switch (1).
5.3. Hammer drilling.
Place the switch (2) the symbol “hammer drilling.” Switch (2) falls in the correct position
with a distinct twinge.
Long lasting drilling at low rotational speed of the spindle may cause motor overheating.
Make periodic breaks in operation. Do not cover holes for motor ventilation in the hammer drill
body.
It must be done to change the direction of rotation when the spindle rotates a drill!
5.3.1. When you need to vent large diameter, is recommended first to break a small opening,
which will then be drilling to the desired size. This will prevent overloading the drill. Drilling
deep holes should be done gradually, as periodically removed from the drill hole to remove
chips or dust. If during drilling to drill block up in holes, you should exclude drill. Use a change
of direction of rotation to remove the drill from the hole. Drill must be kept in alignment with
the hole. Ideally, the drill should be placed perpendicular to the surface of the material being
processed. If the condition for perpendicularity is not respected at work can lead to trapped or
breakage in drill hole and injury to the user.
Make periodic breaks at work.
Keep and refer to the accessories carefully.
Do not throw the tool, do not overload, do not soak in water and other liquids do not use it
for mixing adhesives and concrete coatings.
6. Service and support.
6.1. Striking drill does not require additional lubrication or special maintenance. There are
no parts requiring maintenance by the user. Never use water or any liquid chemical cleaning
drill. It should only be wiped with a piece of dry tissue. Should always be stored in a dry place
and ventilation holes in the body of the drill to be free.
6.2. Replacing carbon brushes. Worn-out (shorter than 5 mm), up or broken engine
carbon brushes should be replaced. Always replace both brushes simultaneously. Work on
replacement of carbon brushes entrusted only to qualified person with original spare parts in
service of business RAIDER.
6.3. The repair of your power is best carried out only by qualified specialists in workshops
RAIDER, which used only original spare parts. Thus ensuring their safe operation.
7. Environmental protection.
In view of environmental power tools, additional accessories and packaging must be
subjected to appropriate processing for reuse of the information contained in these materials.
Do not dispose of household waste power tools! Under the EU Directive 2012/19/EC on
scrapped electrical and electronic equipment and promoting law and national power tools,
which can not be used more, must be collected separately and be subjected to appropriate
processing for recovery of contained therein scrap.
Summary of Contents for RDP-HD30
Page 49: ...49 EXPLODED VIEW OF RDP HD30 ...
Page 66: ...66 www raider bg ...
Page 70: ...70 www raider bg ...
