GT1670-WSB3
3b
Power Socket
Computer SATA Port
Computer 1394b Port
Computer USB Port
3b. Connect GT1670-WSB3 via either USB 3.0, eSATA, or 1394b cable to the computer.
Link AC power cable to the adapter and then connect each connector to GT1670-WSB3
and computer, then, power on GT1670-WSB3.
1. Press tray button and take out the tray.
2. Install your hard disks into the removable trays and secure them with the screws from
accessory kit. This will protect your hard disk from any unnecessary movement.
3a.Connect GT1670-SB3 via either USB3.0 or eSATA to the computer.
Link AC power cable to the adapter and then connect each connector to GT1670-SB3
and computer, then, power on GT1670-SB3.
GT1670-SB3 / GT1670-WSB3 Front View
GT1670-SB3 Rear View
GT1670-WSB3 Rear View
GT1670-SB3/GT1670-WSB3 Quick Installation Guide
Blue and Purple flash
GT1670-SB3
GT1670-WSB3
Status
Access
Blue / Blinks
Blue Lights / On
Disk Idling
Blue Lights / On
Blue Lights / On
Power On
Blue Lights / On
1.Please be noted that two host interfaces cannot be used at the same time, data transmission can
only be done through an interface with a computer.
2.When changing to another host interface, please power off GT1670 and connect to another port
before powering it on again.
3.Please power off GT1670 before exchanging HDD, and then power it on after the HDD is exchanged.
GT1670 Device
USB 3.0 Cable
eSATA Cable
DC Adaptor
1. Please ensure that the hard drives are free of bad tracks before using, otherwise, it may cause
system crash in turn resulting in data loss.
2. No matter which host interface is used for connection, before taking out the hard drive, please
safely remove it via computer operating system.
3.To avoid data corruptions or data loss, it is strongly suggested not to withdrawing hard drive from
the device or powering off the device while data is accessing.
4. Do not remove the hard drive(s) while the system is powered on. Always remember to power off
the system when removing the hard drives.
2.5” or 3.5”HDD Screws
GT1670-SB3
3a
Computer SATA Port
Computer USB Port
Power Socket
1.Open Key Lock.
2.Press Tray Button.
3.Take Out The Tray.
4.Hardware Installation is completed and the OS will automatically recognize your hard
drive once the computer booting is done. If your hard drive needs to be formatted, please
follow the format procedures. After the formatting is completed, you can start to use the
hard drive.
LED Indicators
Tray Button
Thank you for choosing product from
RAIDON Technology Inc
. This information in the manual
has been thoroughly checked before publication, but may not conform to the product actually
delivered which meam actual product specifications depend on the product shipped to you.
Any update in the specifications or product-related information shall not be subject to further
notice but for the latest information on the product, please visit the website as
www.raidon.com.tw
or contact us at
supporting@raidon.com.tw
, and we will get back to
you as soon as possible.
V1.1 (Jan. 2019)
Screws and keys
