RailKing AS-616 Diesel Engine with PS-2
9
Tips on Using FYS
•You can terminate FYS at any time by turning off power to the
track for 15 seconds.
•You do not have to be in Forward to use FYS. At the conclusion
of the full sequence, the train will pull away from the station in
whatever direction you were going when you activated the feature.
•You can use FYS even if you are double-heading with another
engine. If the second engine is not equipped with Proto-Sound 2.0,
you must remember not to leave the throttle at a high voltage level
once you have stopped the engine to run the FYS. Otherwise, the
engine without FYS will begin vibrating on the track as its motors
strain to move the train, since they cannot be automatically disabled
during the FYS cycle (or if an original Proto-Sound engine, FYS are
triggered differently and that engine's motor-disable feature will not
be active when you run FYS in Proto-Sound 2.0).
•FYS can be triggered from Neutral. It will operate the same as if
triggered while in motion except that, at the conclusion of the FYS,
the engine will depart in the next direction of travel, as opposed to
the direction it was traveling before entering Neutral.
Proto-Coupler® Operation
This locomotive is equipped with one or more coil-wound Proto-Couplers for
remote uncoupling action. Because Proto-Couplers are controlled through the
Proto-Sound 2.0 microprocessor, they do not require an uncoupling track section
or modification to your layout to function. You can fire a coupler from neutral or
while in motion. Use the code shown below (and in the chart on page 7) to fire the
coupler(s).
Rear Coupler:
To fire the rear coupler, quickly tap the Bell button once followed by three quick
taps of the Whistle/Horn button, allowing approximately ½ second to lapse
between each quick button press. The sound of the liftbar and air line depletion
will play, and the knuckle will be released.
Horn
Horn
Fire
Rear
Coupler
=
Horn
Bell
