PIKUS 105/105DL – PIKUS 75/75DL
ENGLISH
10
Cutting
BEFORE TURNING ON THE MACHINE, ADJUST THE DISK GUARD SO THAT IT IS
TOUCHING THE TILE TO CUT AND TIGHTEN THE ADJUSTMENT KNOB
IMPORTANT: BEFORE CUTTING,
MAKE CERTAIN THAT THE COLUMN
LOCK (A) AND THE MOTOR HOIST
KNOBS (B) ARE FIRMLY TIGHTENED.
To prevent bending or warping the disk and
overloading the motor, the motor assembly forward
speed during the cut must be proportional to the
hardness of the material to be cut.
ATTENTION: WHEN MAKING PAR-
TICULARLY THICK CUTS (MAX
80/70mm), IT IS BEST TO PASS OVER
THE MATERIAL SEVERAL TIMES AS
REQUESTED BY ITS HARDNESS.
•
Press the start button.
•
Wait until the cooling water reaches the diamond
disk.
•
Proceed with cutting, slowly bringing the diamond disk up against the material to
be cut.
•
Continue cutting keeping the forward speed steady.
•
Towards the end of the cut, reduce speed.
If the end of the tile (the last centimeter) breaks, sharpen the diamond disk.
If this does not eliminate the problem, it can be resolved as follows:
•
make a 2 cm cut at one end of the tile.
•
then turn the tile and make a cut running all the way to the previous 2 cm cut.
IMPORTANT: WHEN CUTTING, BEAR IN MIND THE INSTRUCTIONS GIVEN IN THE
“WORKSTATION” PARAGRAPH (PAGE 4)
MAKE SURE THERE IS ENOUGH CLEAN WATER IN THE TANK TO ENTIRELY COVER
THE PUMP.
DIRTY WATER CAN LEAD TO IMPROPER OPERATION OR EVEN THE BREAKAGE OF
THE PUMP.
USE THE TAP PROVIDED TO ADJUST THE FLOW OF
WATER DELIVERED TO THE DISK.
F
IG
.
9
A
D
Summary of Contents for PIKUS 105
Page 1: ...GB...
Page 2: ......
Page 16: ...PIKUS 105 105DL PIKUS 75 75DL ENGLISH 16...
Page 19: ......
